Manual Hydraulic Test Stand

The test stand use a hydraulic jack to apply force, and have a design that allows forces to be applied in tension or compression.

Attention: When you fix the sensor and jack, please fix the them on the center of the load platform. The direction of the force, which is measured, is on the center line of the test stand.

Precaution:
1.During the fracture test, please wear the protective mask and glove. That will prevent the danger from the  scattering piece in  the testing.
2.Do not use the damaged or warped clamp.The damaged or warped clamp may be off or rupture. The tested material will fall. Be great careful, to avoid hurt your body.
3.Do not bring the load excess the capacity of sensor. The sensor will be damaged with excessive load.Excessive load will load will bread sensor and cause accident