Introduction :

Integrator UE500 is a high quality UV measuring instrument .

UE500 Integrator is used to measure UV energy of different light

sources, especially on printing machines.It is ideal to ensure

quality control of printing and UV drying processes .

It is measuring an integral in the spectral range from 250-410nm,

with a peak at the area of 365nm.By addition of the incidence of

the light quantities during the exposure cycle, relative values

are calculated.Because of uneven radiation distribution of the

UV light source and different type of the construction of the

measuring devices by different manufacturers, different

readings may appear under the same measurement conditions.

Introduction For Use:

1: Switch on the UV-Integrator,the display will show “0”

2: Place the UV-Integrator with the front facing the conveyer belt.

The sensor is on the back.

The back plate of the UV-Integrator serves as the heat shield.

3: After the UV-Integrator has passed through the conveyer,

take the UV-Integrator from the conveyer belt in order to

read the measuring result.

The measuring results are show as : mj/cm².

4: Prior to a new measuring sequence , it is necessary to switch

“off” and then “on” again.

This will reset the display to “0”.

Continue as described in step 2.

Attention :

1: Please avoid shaking the UV-Integrator .

2: UV-light is hazardous to your health. Avoid direct UV-light

to your eye and to your body.